APL 1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed V, V and V. Features. Guaranteed Output Voltage Accuracy within. APLVC-TU 1A Low Dropout Fast Response Positive Regulator Fixed V and V 1A, Details, datasheet, quote on part number: APLVC-TU. APLUC-TU from Anpec Electronics Corp.. Find the PDF Datasheet, Specifications and Distributor Information.
|Published (Last):||3 March 2015|
|PDF File Size:||8.22 Mb|
|ePub File Size:||3.18 Mb|
|Price:||Free* [*Free Regsitration Required]|
Home – IC Supply – Link.
On-chip thermal limiting provides protection against any combination of overload that would create excessive junction temperatures. If R1 were con- nected to daatasheet load, RP is multiplied by the divider ratio, the effective resistance between the regulator and the load would be: For fixed voltage devices the top of R1 is internally connected to the output, and the ground pin can be connected to low side of the load.
By plac- ing a resistor between these two terminals, a con- stant Current is caused to flow through R1 and down through R2 to set the overall output voltage. The APL is a low dropout three-terminal adjustable. The output available volt- age range of an adjustable version is from 1. Best load regulation is obtained. Apl11117 fixed voltage devices the top of R1 is internally. The data sheet speci. X C should be approximately equal to R1 at ripple frequency ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and advise customers to obtain the latest version of relevant information to verify before placing orders.
On-chip thermal limiting provides.
Proper capacitor selection is important to ensure proper operation. The data sheet speci- fication ap1117 load regulation is measured at the output pin of the device. The APL output capacitor selection is dependent upon the ESR equivalent series resistance of the output capacitor to maintain stability.
Current limit is trimmed to ensure specified output current and controlled short-circuit current. This will improve transient response as well as pro- mote stability.
Результаты поиска для APL1117-AH
The output available volt. Best load datasehet is obtained when the top of the resistor divider R1 is tied di- rectly to the output pin of the device, not to the load. Load Regulation When the adjustable regulator is used.
Simplified Application Circuits 1. X C should be approximately.
Normally this current is chosen to be the specified minimum load current of 10mA. Basic Adjustable Regulator ues will improve ripple rejection by bypassing the in- put to the regulator. For fixed voltage devices R1 and R2 are included in the device. Dropout voltage datasehet guar. This will improve transient response as well as pro. ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and.
In order to obtain lower dropout voltage and faster transient response, which is critical for low voltage a;l1117, the APL has been optimized.
The device is available in an adjustable version and fixed output voltages of 1. When the adjustable regulator is used. Load regula- tion will be limited by the resistance of the wire con- necting the regulator to the load.
APL Datasheet(PDF) – Anpec Electronics Coropration
A low-ESR solid datasjeet capacitor works extremely well and provides good transient re- sponse and stability over temperature. Tantalum, or aluminum electrolytic capacitors can be used for bypassing.
The device is available. Dropout voltage is guar- anteed at a maximum of 1.