APL 1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed V, V and V. Features. Guaranteed Output Voltage Accuracy within. APLVC-TU 1A Low Dropout Fast Response Positive Regulator Fixed V and V 1A, Details, datasheet, quote on part number: APLVC-TU. APLUC-TU from Anpec Electronics Corp.. Find the PDF Datasheet, Specifications and Distributor Information.
|Published (Last):||9 March 2011|
|PDF File Size:||13.59 Mb|
|ePub File Size:||11.47 Mb|
|Price:||Free* [*Free Regsitration Required]|
When the adjustable regulator is used. The APL is a low dropout three-terminal adjustable. By plac- ing a resistor between these two terminals, a con- stant Current is caused to flow through R1 and down through R2 to set the overall output voltage.
Tantalum, or aluminum electrolytic capacitors can be used for bypassing. For fixed voltage devices the top of R1 is internally. The APL output capacitor selection is dependent upon the ESR equivalent series resistance of the output capacitor to maintain stability. On-chip thermal limiting provides protection against any combination of overload that would create excessive junction temperatures.
The device is available. This will improve transient response as well as pro. Home – IC Supply – Link.
APL Datasheet(PDF) – Anpec Electronics Coropration
Dropout voltage is guar. X C should be approximately equal to R1 at ripple frequency ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and advise customers to obtain the latest version of relevant information to verify before placing orders. On-chip thermal limiting provides. For fixed voltage devices R1 and R2 are included in the device.
If R1 were con- nected to the load, RP is multiplied by the apl1171 ratio, the effective resistance between the regulator and the load would be: A low-ESR solid tantalum capacitor works extremely well and provides good transient re- sponse and stability over temperature. For fixed voltage devices the top of R1 is internally connected to the output, and the ground pin can be connected to low side of the load.
The device is available in an adjustable version and fixed output voltages of 1. X C should be approximately.
Результаты поиска для APL1117-AH
The output available volt. Basic Adjustable Regulator ues will improve ripple rejection by bypassing the in- put to the regulator. This will improve transient response as well as pro- mote stability. Normally this current is chosen to be the specified minimum load current of 10mA. Load regula- tion will be limited by the resistance of the wire con- necting the regulator to the load.
Proper capacitor selection is important to ensure proper operation. The data sheet speci- fication for load regulation is measured at the output pin of the device. The data sheet speci.
APL1117 Datasheet PDF
Simplified Application Circuits 1. Load Regulation When the adjustable regulator is used. Current limit is trimmed to ensure specified output current and controlled short-circuit current.
ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and. In order to obtain lower dropout voltage and faster transient response, which is critical for low voltage applications, the APL has ratasheet optimized. The output available volt- age range of an adjustable dahasheet is from 1.
Dropout voltage is guar- anteed at a maximum of 1. Best load regulation is obtained when the top of the resistor divider R1 is tied datzsheet rectly to the output pin of the device, not to the load. Best load regulation is obtained.