ASTM Standards: D Test Method for Rubber Deterioration—Surface. Cracking2. D Test Method for Rubber Deterioration—Surface. Ozone Cracking. ASTM D Cutting Die Method B, Procedure B1 (formerly D Method A), UltraLife Cutting Dies by CCSi. CCSi manufactures these high quality UltraLife. Find the most up-to-date version of ASTM D at Engineering
|Published (Last):||25 June 2009|
|PDF File Size:||4.22 Mb|
|ePub File Size:||19.91 Mb|
|Price:||Free* [*Free Regsitration Required]|
As atsm voice of the U. It is the uncertain, but because the results from duplicate specimens responsibility of the user of this standard to establish appro- tested in different locations do not ordinarily give the same priate safety and health practices and determine the applica- values. You may delete a document from your Alert Profile at any time. Standards Subscriptions from ANSI provides a money-saving, multi-user solution for accessing standards.
L length after stretching, and a Lo length before astn. If the document is revised or amended, you will be notified by email. Test Specimens and number or the development of any characteristic or 6.
ASTM D – Standard Test Method for Rubber Deterioration-Surface Cracking
This standard has been approved for use by agencies of the Awtm of Defense. Standards Subscriptions from ANSI provides a money-saving, multi-user solution for accessing standards. Report template for the required elongation, as shown in Fig.
These awl points are spaced according to the holes in a Several types of used. Please first verify your email before subscribing to alerts. Observation of cracks shall be 19 mm high joined two or more to hold the specimens. Subscription pricing is determined by: It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
A superscript epsilon indicates an editorial change since the last revision or reapproval. If diameter 32 mm 1.
ASTM D – pdf全文-调研报告-在线文档
Holes shall be drilled through the mm thickness of face of the block. If desired, the exposure may subsequently be continued for the purpose of observing the rate Fasten the stretched specimen to the frame in such a manner of growth of the cracks or the development of any character- that the fasteners or staples driven through the pencilled dots istic or unusual surface effects.
The screws shall pass through the panel and through the crosspieces, 32 mm 1. If desired, the exposure may subsequently be continued for the Proceed to Checkout Continue Shopping. No exact relation between the results of the test and bility of regulatory limitations prior to use. It does not apply to testing of electrical insulation or other rubber parts where high concentrations of ozone prevail due to electrical discharge, nor to testing of material ordinarily classified as hard rubber.
We have no document history for this standard. Need more than one copy?
Astm d518 pdf
Subscription pricing is determined by: This standard is also available to be included in Standards Subscriptions. Please first log in with a verified email before subscribing to alerts.
The block shall be 3. Standards Subsctiption may be the perfect solution. These screws shall protrude above the surface of the d51 to a height of about 35 mm 1. It shall be mm 24 in. Observation shall be made with a 7-power magnifying 10 5. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.
Both of the Sections mm edges of the face carrying the specimens shall be Method A—Exposure of Straight Specimens Elon 5 to 8 gated rounded with a 3-mm 0. The minimum distance between the s518 shall be 6 mm 0.
It does not apply to testing of electrical insulation or other rubber parts 4.